Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Info

Lift back on each corner of the rear section of the engine cover. You will notice it will “pop” up easily with little effort. 

Note

Note that on the front portion of the engine cover, you will see two clips that will need to be disconnected from the air duct. (as seen below)

Image Added

Info

Pull back on these clips gently.

Image Added
Info

Once removed, place the engine over to the side.

Image Added
Info

You now see the ECU located in the center of the engine bay.

Image Added
Info

Located at the rear of the ECU, you will see the two ECU CONNECTORS. 

Image Added
Info

Unlock the driver side connector.

Image AddedImage AddedImage Added
Info

Unlock the passenger side ECU connector

Image AddedImage AddedImage Added
Info

Pull up in the front of the ECU, you will notice the ECU will “un-clip”. Do the same for the rear.

Image Added
Tip

Congratulations! The ECU has been removed!

Image Added
Note

When receiving your ECU. Please ensure that you carefully re-install the factory clips onto the ECU gently. Once the ECU is re-installed correctly. Re-connect your battery and start your vehicle. Failure to do so can cause the vehicle to not start / not run right / or cause damage to the ECU.